10
2 HIGH-SPEED COUNTER MODULE FB
2.1 M+FX5-2HC_CountEnable (Count Enable Operation)
FB details
Available device
Basic specifications
Processing
• By turning on or off i_bEN (Execution command), the count operation starts or stops.
• When i_bEN (Execution command) is on, the contents of CH1 in operation (Un\G28.1)/CH2 in operation (Un\G68.1) are
output to o_bCountStart (Count in operation flag).
• After i_bEN (Execution command) turns on, o_bOK (Normal completion) turns on when the target channel starts operating.
Target module Firmware Version Engineering tool
FX5UJ CPU module 1.060 or later GX Works3 Version 1.100E or later
FX5U CPU module 1.300 or later GX Works3 Version 1.100E or later
FX5UC CPU module 1.300 or later GX Works3 Version 1.100E or later
High-speed counter module 1.000 or later GX Works3 Version 1.100E or later
Item Description
Language Ladder diagram
Number of steps 410 steps
The number of steps of the FB embedded in a program depends on the CPU module used, the input/output definitions,
and the options setting of GX Works3. For the option settings of GX Works3, refer to the following.
GX Works3 Operating Manual
The amount of label usage • Label: 332 points (Word)
• Latch label: 0 points (Word)
The amount of labels used in the program varies depending on the CPU module used, the device specified in an
argument, and the option setting of GX Works3. For the option settings of GX Works3, refer to the following.
GX Works3 Operating Manual
The number of index register
usage
• Index register: 0 points
• Long index register: 0 points
The amount of file register usage File register: 0 points (Word)
FB dependence No dependence
FB compilation method Macro type
FB operation Always executed
To Next Page
Loading...
