Mitsubishi Electric MELSEC-Q Series - Writing Programs to the CPU Module

24
 Writing programs to the CPU module
Operating procedure
The "Write to PLC" screen is displayed.
When the Write to PLC function is properly executed, the following message is displayed.
The program writing is completed.
Click to close the "Write to PLC" screen.
Point
 PLC parameter
The PLC parameter is necessary to start the CPU module. The default values are used in
this system configuration.
For details of setting parameters, refer to the following manuals.
Qn(H)/QnPH/QnPRHCPU User's Manual (Function Explanation, Program
Fundamentals): SH-080808ENG
QnUCPU User's Manual (Function Explanation, Program Fundamentals):
SH-080807ENG
1 Select [Online]
 [Write to PLC] ( ).
4 Click the button.
2 Click "Param+Prog".

3
"Program" and "Parameter"
are checked.
5 Click the button.