8 - 16
CHAPTER8 PARAMETERS
1
2
3
4
5
6
7
8
8.1 PLC Parameters
(12) Multiple CPU settings Note8.3íç1
Parameters required for configuring a multiple CPU system are set.
(To the next page)
注1
Figure 8.12 Multiple CPU settings
Table8.12 Multiple CPU setting list
Item
Parameter
No.
Descriptionì‡Å@óe Setting range Default Reference
No. of PLC 0E00
H
Set the number of CPU modules used in a multiple
CPU system.
1 to 4 1
QCPU Userís
Manual (Multiple
CPU System)
Host CPU
number
*1
E00CH
Set a CPU number for which the multiple CPU
setting parameters are set. (Set the number of the
connected CPU module.)
PLC No.1 to No.4 Blank
Operating mode 0E01
H
Select the multiple CPU system operation to be
performed in case a stop error occurs in any of
CPU No.2 to No.4.
When CPU No.1 results in a stop error, the multiple
CPU system stops. (Fixed)
Selected/
deselected
All items selected
Multiple CPU
synchronous
startup setting
*1
E00BH
Enable or disable synchronous startup of the CPU
modules on the multiple CPU system.
Mp.1 to No.4 All items selected
Note8.3
The Q00UJCPU cannot be used in multiple CPU systems.
Universal
To Next Page
Loading...
