EasyManua.ls Logo

Mitsubishi Electric MIFH1 - Regulatory and Specifications; FCC Compliance and RF Exposure; System Specifications and Parts

Mitsubishi Electric MIFH1
12 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© 2010 Mitsubishi Electric & Electronics USA, Inc.
Suwanee, GA 30024 All Rights Reserved.
The three diamond logo is a registered trademark
of Mitsubishi Electric Corporation
69-2426—01M.S.11-10
PrintedinU.S.A.
Regulatory information
FCC Compliance Statement (Part 15.19) (USA only)
ThisdevicecomplieswithPart15oftheFCCRules.Operationissubjecttothefollowingtwoconditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including interference that may cause undesired operation.
FCC Warning (Part 15.21) (USA only)
Changesormodificationsnotexpresslyapprovedbythepartyresponsibleforcompliancecouldvoidtheuser’sauthorityto
operate the equipment.
FCC Interference Statement (Part 15.105 (b)) (USA only)
ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,pursuanttoPart15ofthe
FCCRules.Theselimitsaredesignedtoprovidereasonableprotectionagainstharmfulinterferenceinaresidentialinstallation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions,maycauseharmfulinterferencetoradiocommunications.However,thereisnoguaranteethatinterferencewillnot
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
• Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
Wireless receiver, remote controller and outdoor sensor
TocomplywithFCCandIndustryCanadaRFexposurelimitsforgeneralpopulation/uncontrolledexposure,theantenna(s)used
for these transmitters must be installed to provide a separation distance of at least 20 cm from all persons and must not be
co-locatedoroperatinginconjunctionwithanyotherantennaortransmitter.
Portable Central Controller
ThisportabletransmitterwithitsantennacomplieswithFCCandIndustryCanadaRFexposurelimitsforgeneralpopulation/
uncontrolledexposure.Thisdevicemustnotbeco-locatedoroperatinginconjunctionwithanyotherantennaortransmitter.
Section 7.1.5 of RSS-GEN
Operationissubjecttothefollowingtwoconditions:
1 this device may not cause interference, and
2 this device must accept any interference, including interference that may cause undesired operation of the device.
Specifications & replacement parts
Operating Ambient Temperature
Remote Controller:32to120°F(0to48.9°C)
Portable Central Controller:32to120°F(0to
48.9°C)
Wireless receiver:-40to165°F(-40to73.9°C)
Outdoor air sensor:-40to140°F(-40to60°C)
Operating Relative Humidity
Remote Controller:5%to90%(non-
condensing)
Portable Central Controller:5%to90%(non-
condensing)
Wireless receiver:5%to95%(non-condensing)
Outdoor air sensor:0%to100%(condensing)
Physical Dimensions(height,width,depth)
Remote Controller:3-9/16x5-13/16x1-1/2
inches(91x147x38mm)
Wireless receiver:6-7/16x3-1/4x1-5/16
inches(164x82.5x34mm)
Outdoor air sensor:5x3-1/2x1-11/16inches
(127x89x43mm)
Portable Central Controller:6-1/4x3-1/8x
1-5/8inches(158.2x79.9x42mm)
Item Part Number
PortableCentralController MCCH1
Outdoorairsensor MOS1
RemoteController MRCH1
ReceiverandCable MIFH1
Cable MRC1
Accessories & Replacement Parts

Related product manuals