Mitsubishi Electric MIFH1 - Wireless Device Installation; Battery Installation Procedures; Cable and Receiver Installation

Wireless System Installation Guide
69-2426—01 2
M28474
1
Install batteries in wireless devices
Installbatteriesinalldevices.Makesurebatteriesareinsertedproperly(seepolaritymarks
onthedevices).
2
Install cable and receiver
M28472A
Remote Controller
Portable Central Controller (optional): Install 3 fresh AA batteries
Outdoor air sensor (optional): Install 2 fresh AA lithium batteries
Install 2 fresh AA batteries
Install quick reference card
1 Before mounting indoor unit, connect cable to
the 5-pin CN105 connector on the control board
in the indoor unit.
2 Mount indoor unit. Route cable to preferred
location of the wireless receiver.
3 Route cable through hole in base of wireless
receiver and attach to 5 pin connector on
receiver board.
4 Pushtheexcesscablebackthroughtheindoor
unit or behind the wireless receiver. Do not cut
or modify the cable. Use zip tie connections on
back of receiver if needed.
5 Mountwirelessreceivernexttotheindoorunit
(seebelow)orinaremotelocation.
Mount in the orientations shown. Do not block vents.
MCR31400
X
X
OR
OR