Mitsubishi Electric MIFH1 - Link Optional Devices to Network; Linking Portable Central Controller; Linking Outdoor Air Sensor

Wireless System Installation Guide
69-2426—01 4
Link Portable Central Controller to RedLINK™ network (optional)
Link outdoor sensor to RedLINK™ network (optional)
CONNECT
WIRELESS SETUP
M28481
M28483
NOYES
CONNECT MORE?
M28482
1 MakesuretheCONNECTlightonthe
wireless receiver is flashing.
2 PressCONNECTatthePortableCentral
Controller. There will be a short delay as the
PortableCentralControllerseeksasignal
from the wireless network.
3 Whenthescreendisplays"Connected,"
press DONE.
4 PressNOatthenextscreentosaveandexit.
(OrpressYES and repeat steps 1-4 to link
anotherreceiver.)
1 MakesuretheCONNECTlightonthe
wireless receiver is flashing.
2 PressandreleasetheCONNECT button on the
back of the sensor.
3 Check remote controller to verify that the
outdoor sensor is working. After about
15 seconds, the remote controller should
display outdoor temperature and humidity.
Presstolink
another receiver
Presstosave
andexit
If E1 appears, see error codes on page 10.
The linking procedure may time out if there is
no keypress within 15 minutes. To begin again,
press and holdtheblankspace(orarrow,if
present)inthelowerrightcornerofthescreen
untilthedisplaychanges(about3seconds).
Pressandrelease