Mitsubishi Electric Q01UCPU - Page 482

480
(6) Use of the file register
When "Use the same file name as the program." is selected in the PLC file tab of the PLC parameter dialog box,
the processing time listed in the following table is required. When "Use the following file." is selected, the scan
time will not be increased.
*1 "n" indicates the number of program files.
(7) Online change
When data is written to the running CPU module, the processing time described below is required.
(a) Online change (ladder mode)
When a program in the running CPU module is changed in ladder mode, the processing time listed in the
following table is required.
*1
*1 The time in the table is for the case where the service processing count is set to one.
CPU module Processing time
Standard RAM
Q00UCPU, Q01UCPU 0.135ms
Q02UCPU 0.082ms
Q03UD(E)CPU 0.043ms
Q04UD(E)HCPU, Q06UD(E)HCPU, Q10UD(E)HCPU, Q13UD(E)HCPU,
Q20UD(E)HCPU, Q26UD(E)HCPU, Q50UDEHCPU, Q100UDEHCPU
0.041ms
Q03UDVCPU, Q04UDVCPU, Q06UDVCPU, Q13UDVCPU, Q26UDVCPU
0.016 × n
*1
ms
Standard RAM (with an
extended SRAM
cassette)
Q03UDVCPU, Q04UDVCPU, Q06UDVCPU, Q13UDVCPU, Q26UDVCPU
0.016 × n
*1
ms
SRAM card
Q02UCPU
0.11 × n
*1
ms
Q03UD(E)CPU
0.06 × n
*1
ms
Q04UD(E)HCPU, Q06UD(E)HCPU, Q10UD(E)HCPU, Q13UD(E)HCPU,
Q20UD(E)HCPU, Q26UD(E)HCPU, Q50UDEHCPU, Q100UDEHCPU
0.06 × n
*1
ms
CPU module
Reserved area for online change
The reserved area for online
change is not changed.
The reserved area for online
change is re-set.
Q00UJCPU, Q00UCPU, Q01UCPU Up to 2.1ms Up to 2.1ms
Q02UCPU Up to 1.3ms Up to 1.3ms
Q03UD(E)CPU Up to 1.0ms Up to 1.0ms
Q04UD(E)HCPU, Q06UD(E)HCPU, Q10UD(E)HCPU,
Q13UD(E)HCPU, Q20UD(E)HCPU, Q26UD(E)HCPU,
Q50UDEHCPU, Q100UDEHCPU
Up to 0.7ms Up to 0.7ms
Q03UDVCPU, Q04UDVCPU, Q06UDVCPU,
Q13UDVCPU, Q26UDVCPU
Up to 0.6ms Up to 0.6ms