Mitsubishi Electric Q13UDVCPU - Page 379

377
APPENDICES
A
Appendix 1 Error Codes Appendix 1.6 List of error codes (4000 to 4999)
4100
[OPERATION ERROR]
The instruction cannot process the contained data.
■Collateral information
• Common information: Program error location
• Individual information: -
■Diagnostic timing
• When instruction executed
Read common information of the error using
the programming tool to identify the numeric
value (program error location). Check the
error step corresponding to the value, and
correct it as necessary.
RUN: Off/On
ERR.:Flashing/On
CPU Status:
Stop/Continue
*1
QCPU
LCPU
[OPERATION ERROR]
An error has occurred in access to the ATA or SD
memory card using an instruction.
■Collateral information
• Common information: Program error location
• Individual information: -
■Diagnostic timing
• When instruction executed
• Take noise reduction measures.
• Reset the CPU module and run it again. If
the same error code is displayed again, the
cause is a hardware failure of the ATA card
or SD memory card. Please consult your
local Mitsubishi representative.
Qn(H)
QnPH
QnPRH
QnU
LCPU
[OPERATION ERROR]
• The file being accessed was accessed with the
SP.FWRITE instruction.
• Writing was attempted to the write-protected SD
memory card with the SP.FWRITE instruction.
■Collateral information
• Common information: Program error location
• Individual information: -
■Diagnostic timing
• When instruction executed
• Do not execute the SP.FWRITE instruction
to the file being accessed.
• Do not execute any other function and the
SP.FWRITE instruction at the same time.
• Disable the write protect switch of the SD
memory card.
QnU
LCPU
Error
code
Error and cause Corrective action
LED status,
CPU status
Corresponding
CPU