Mitsubishi Electric Q13UDVCPU - Page 466

464
*1 Modules whose function version B or later
*2 Modules whose serial number (first five digits) is "09012" or later
*3 Modules whose serial number (first five digits) is "04122" or later
*4 Modules whose serial number (first five digits) is "07032" or later
*5 Universal model QCPU except the Q00UJCPU, Q00UCPU, Q01UCPU, and Q02UCPU
*6 The following modules support this area:
• Universal model QCPU whose serial number (first five digits) is "10012" or later
• Q13UDHCPU, Q26UDHCPU
*7 Universal model QCPU except the Q00UJCPU
*8 Modules whose serial number (first five digits) is "12052" or later
*9 Modules whose serial number (first five digits) is "15042" or later
*10 Modules whose serial number (first five digits) is "15043" or later
*11 Modules whose serial number (first five digits) is "15102" or later
SM330
Operation mode for
low speed
execution type
program
OFF: Asynchronous
mode
ON: Synchronous
mode
Select whether the low speed execution
type program will be executed in the
asynchronous mode or in the
synchronous mode.
• Asynchronous mode (this relay is
turned off.) The operation of the low-
speed execution type program is
performed continuously within an
excess time.
• Synchronous mode (this relay is turned
on.) The operation of the low-speed
execution type program is not
performed continuously, but performed
from the next scan, even if there is
excess time.
UNew
Qn(H)
QnPH
SM331
Normal SFC
program execution
status
OFF: Not executed
ON: Being executed
• This relay stores the information on
whether the normal SFC program is in
execution or not.
• Used as an interlock for execution of
the SFC control instruction.
S (Status
change)
New
Qn(H)
*3
QnPH
*4
QnPRH
SM332
Program execution
management SFC
program execution
status
OFF: Not executed
ON: Being executed
• This relay stores the information on
whether the SFC program for program
execution management is in execution
or not.
• Used as an interlock for execution of
the SFC control instruction.
S (Status
change)
New
Qn(H)
*3
QnPH
*4
QnPRH
SM339
Latch clear
execution
command
OFF  ON:Latch clear
executed
Except OFF  ON:
Latch clear not
executed
The latch data is cleared while this relay
is turned on in the STOP status. When
5A01
H
is set to SD339, this relay will be
valid.
UNew
QnUDV
*10
LCPU
*9
SM390
Access execution
flag
ON indicates
completion of intelligent
function module access
• This relay stores the status information
on the intelligent function module
access instruction that was just
executed. (This data is overwritten if
the intelligent function module access
instruction is executed again.)
• Used by the user in a program as a
completion bit.
S (Status
change)
New
Qn(H)
QnPH
QnPRH
SM391
GINT instruction
execution
completion flag
OFF: Not executed
ON: Execution
completed
Stores the execution status of the
S(P).GINT instruction.
• Turns off before execution of the
instruction.
• Turns on after completion of the
instruction.
S
(Instruction
execution)
New
Q00/Q01
Qn(H)
*1
QnPH
QnU
*7
Number Name Meaning Explanation
Set by
(When Set)
Corresponding
ACPU
M9
Corresponding
CPU