Mitsubishi Electric Q13UDVCPU - Page 504

502
SM1910
CH2
coincidence
signal No.1
reset command
Resets CH2 counter
value coincidence No.1.
• This relay is turned on to reset CH2
counter value coincidence No.1.
• The command is valid while this relay is
on.
• The on time must be held for at least 2ms.
UNewLCPU
SM1911
CH2
coincidence
signal No.2
reset command
Resets CH2 counter
value coincidence No.2.
• This relay is turned on to reset CH2
counter value coincidence No.2.
• The command is valid while this relay is
on.
• The on time must be held for at least 2ms.
UNewLCPU
SM1912
CH2
coincidence
output enable
command
Controls outputs from
CH2 coincidence output
No.1 and No.2 terminals.
• This relay is turned on to perform
coincidence output from CH2 coincidence
output No.1 and CH2 coincidence output
No.2 terminals.
• The command is valid while this relay is
on.
UNewLCPU
SM1913
CH2 preset
command
Presets the counter
value.
• This relay is turned on to preset the
counter value.
• The command is valid at the rise of this
relay (off  on).
• The on and off time must be held for at
least 2ms.
UNewLCPU
SM1914
CH2 count down
command
Counts down pulses.
• This relay is turned on to count down
pulses.
• The command is valid while the Pulse
input mode is either 1-phase multiple of n
or 1-phase multiple of n (A phase only).
• The command is valid while this relay is
on.
UNewLCPU
SM1915
CH2 count
enable
command
Starts counting.
• This relay is turned on to start counting.
• The command is valid while this relay is
on.
UNewLCPU
SM1916
CH2 counter
function
selection start
command
Starts the selected
counter function.
• This relay is turned on to start the
selected counter function.
• When the count disabling function is
selected, the command is valid while this
relay is on.
• When the latch counter function or the
sampling counter function is selected, the
command is valid at the rise of this relay
(off  on). The on time must be held for
at least 2ms.
• When the count disabling/preset function
or the latch counter/preset function is
selected, the command is invalid.
UNewLCPU
SM1917
CH2 external
preset (phase Z)
request
detection reset
command
Resets CH2 external
preset (phase Z) request
detection.
• This relay is turned on to reset CH2
e
xternal preset (phase Z) request
detection.
• The command is valid at the rise of this
relay (off  on).
• The on and off time must be held for at
least 2ms.
UNewLCPU
SM1918
CH2 pulse
measurement
start command
Starts pulse
measurement.
• This relay is turned on to measure pulses.
• The command is valid while this relay is
on.
UNewLCPU
SM1919
CH2 error reset
command
Resets the CH2 error.
• This relay is turned on to reset the CH2
error.
• The command is valid at the rise of this
relay (off  on).
• The on and off time must be held for at
least 2ms.
UNewLCPU
Number Name Meaning Explanation
Set by
(When Set)
Corresponding
ACPU
M9
Corresponding
CPU