Mitsubishi Electric XD510U User Manual (English)

Other manuals for Mitsubishi Electric XD510U

Questions and Answers:

J
Jesus ObrienAug 27, 2025
Why are the images shaking on my Mitsubishi Electric Projector?
- J
  Jenny JamesAug 27, 2025
  If the projected images from your Mitsubishi Electric Projector are shaking or displaced, ensure the cable connected to the external device isn’t intermittent and firmly connect the cable’s plug to the external device’s connector. You can also press the AUTO POSITION button. If you are using WXGA video signal, confirm the setting selected in WXGA in the FEATURE menu. If the problem persists, adjust the SIGNAL menu, as some computers may output out-of-spec signals.
J
James MillerAug 26, 2025
How to fix blurry images on Mitsubishi Electric XD510U?
- M
  Michael LoveAug 27, 2025
  If the projected images from your Mitsubishi Electric Projector are blurred, try adjusting the focus. Clean the lens. Press the W or X button on the remote control to eliminate flicker. Adjust TRACKING and FINE SYNC in the SIGNAL menu. Adjust BRIGHTNESS and CONTRAST in the IMAGE menu. Make sure that the projector and the screen are perpendicular to each other.
C
Carolyn GriffithAug 25, 2025
Why does my Mitsubishi Electric XD510U Projector keep turning off?
- L
  Lauren HuberAug 26, 2025
  If your Mitsubishi Electric Projector's power turns off unexpectedly, it may be due to blocked intake or exhaust vents. Remove any obstructions and then wait for the fans to stop (until the STATUS indicator goes out). Unplug the power cord from the wall outlet, wait about 10 minutes, then plug it back in and press the POWER button. Also, check if AUTO POWER OFF is set to OFF. A steady red STATUS indicator means the lamp needs replacing. Finally, if the lamp has deteriorated, it may go out after a short time.
D
Deborah MartinAug 23, 2025
How to fix no image on Mitsubishi Electric XD510U screen?
- D
  devonfarleyAug 23, 2025
  If no image appears on the screen of your Mitsubishi Electric Projector, first cancel the AV mute by pressing the AV MUTE button. Also, ensure that the lens cap is removed. It can take up to 1 minute for the lamp to light up. If the lamp doesn't light, wait a few minutes and try again. If the projector was turned off before the lamp cooled down, wait for the fan to stop, then press the POWER button. Ensure the intake vent is clean and the lamp cover is closed. Check the cables and replace any extension cables with the supplied cable. If images then display correctly, add an RGB signal amplifier to the extension cable. Set SCART INPUT in the FEATURE menu to OFF.
L
Lisa MaciasSep 14, 2025
Why do afterimages persist on the screen of my Mitsubishi Electric Projector?