Mitsubishi 4g63 - Crankshaft and Cylinder Block - Part 1; Crankshaft and Cylinder Block Removal

HOW TO USE THIS MANUAL
ENGINE OVERHAUL <4G63-Turbo>
11D-3
ENGINE OVERHAUL
11-54
CRANKSHAFT AND CYLINDER BLOCK
REMOVAL AND INSTALLATION
Section titlePage number
Procedures and cautions for removal, instal-
lation, disassembly, and reassembly are ex-
plained under this category of heading.
The alphabetical character in this category of
heading matches that of the relevant removal
steps, installation steps, disassembly steps, or
reassembly steps.
Denotes non-reusable part.
Tightening torque
CRANKSHAFT AND CYLINDER BLOCK
Removal steps
1. Drive plate bolt
2. Adapter plate
3. Drive plate
4. Crankshaft bushing
5. Rear plate
6. Bellhousing cover
>>E<< 7. Oil seal case
>>D<< 8. Oil seal
>>C<< 9. Bearing cap bolt
10. Bearing cap
>>B<< 11. Crankshaft bearing, lower
>>A<< 12. Crankshaft
>>A<< THRUST BEARING INSTALLATION
INSTALLATION SERVICE POINTS
AK100786
AB
Grooves
Group title
AK300250
AK204351
AB
Apply engine oil
to all moving
parts before
installation.
1
2
3
4
5
6
7
8
9
11
12
13
14
15
16
10
25 ± 2 N·m + 90º to 100º
11 ± 1 N·m
132 ± 5 N·m
9.0 ± 1.0 N·m
11 ± 1 N·m
A