EasyManuals Logo

Mitsubishi CR800 Series User Manual

Mitsubishi CR800 Series
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
1Error list
Error no. L5420
1-54
L5420 Error message Illegal slot No.
Cause A task slot number other than 1 through TASKMAX (parameter) is specified.
Measures Designate the correct task slot.
L5430 Error message Illegal robot No.
Cause The mechanism designation is illegal.
Measures Designate the correct mechanism.
L5600 Error message Cannot execute during an error
Cause Cannot execute during an error.
Measures Reset the error.
C5610 Error message Cannot execute during STOP ON
Cause Cannot execute during stop signal input.
Measures Turn the stop signal OFF and execute.
L5620 Error message Cannot execute during CSTOP ON
Cause Cannot execute during cycle stop signal input.
Measures Turn the cycle stop signal OFF.
L5630 Error message Cannot execute during SRVOFF ON
Cause Cannot execute during servo OFF signal input.
Measures Turn the servo OFF signal OFF.
L5640 Error message Cannot execute during RUN
Cause Cannot execute during operation.
Measures Stop the operation, and then execute.
L5650 Error message Cannot execute during STOP
Cause Cannot execute during stop operation.
Measures Complete the stop, and then execute.
L5660 Error message Edit during RUN (include ALWAYS)
Cause Editing cannot be performed while in operation (including continuous execution).
Measures Stop the program, and then execute.
C5670 Error message Cannot execute during wait
Cause Cannot execute during wait
Measures Execute Program Reset
L5990 Error message System error (Illegal command)
Cause Not exist command was executed.
Measures Execute the correct command.
L6010 Error message Illegal command
Cause This may have occurred because data was sent before the communication line was opened via a data link,
or an unregistered communication command was sent due to the mismatch between the versions of the
controller and support software.
Measures Send after the communication line is opened. Or, match the versions.
L6011 Error message Cannot connect to CR800
Cause Cannot connect to CR800
Measures Please connect to CPU unit
L6020 Error message The Operation is disable
Cause The operation rights have not been acquired.
Measures Acquire the operation rights.
L6030 Error message The editing operation is disable
Cause The editing operation rights have not been acquired.
Measures Acquire the editing operation rights.
L6040 Error message System error (illegal device No)
Cause A non-registered device No. was set.
Measures Set a valid device.
Error No. Error cause and measures

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi CR800 Series and is the answer not in the manual?

Mitsubishi CR800 Series Specifications

General IconGeneral
BrandMitsubishi
ModelCR800 Series
CategoryController
LanguageEnglish

Related product manuals