Mitsubishi CS-27205 - Tv+Cable with a Decoder Box

TV+cable with a decoder box
equipment you will need
Use this hook-up if you need a decoder box to descramble cable
signals. With this hook-up, you will have to change channels on
your cable box, and not on your _[_. You should set: up your remote
control to operate your cable box (page 38).
To complete the hook-up, you'll need:
• one 75-ohm coaxial cable.
procedure
O Connect the incoming cable to the IN terminal on the decoder
box.
O Connect a coaxial cable to the OUT terminal on the decoder box;
connect the other end of this cable to the antenna terminal on
the back of the TV.
Incoming Cable
czar} q Cable Decoder Box
_ Rear Terminals
>------- 75 Ohm
Coaxial Cable
O
-rv Rear Terminals
@
VHF/UHF
{75n)
INPUT I
!_ VIDEO
Basic Connections 27