Setting up and using the remote control
(CS-27305 only)
Important:
Your TV comes with a remote control that not only operates your
TV, but can operate many of the functions of your VCR and cable
box as well.
The remote control is pre-set to operate Mitsubishi VCRs, but it can
also operate VCRs from other manufacturers. If you have a VCR
from another manufacturer, or if you have a cable box, you need to
"set up" the remote control.
Each layer (VCR or AUX) can be set for either a cable box or a VCR.
setting up the remote control to operate :your VCR
Turn off your VCR.
Set the TWVCR/AUX switch on the remote control to "VCR" or
"AUX."
O While holding in the POWER button on the remote control,
enter the code number listed in the chart below for your brand of
VCR. Be sure to enter both digits of the code number. (If more
than one code number is listed, try the first one. If that code
does not work, try the next one until you find the correct code.)
If your VCR is this
brand...
Mitsubishi (A)
Mitsubishi (B)
Canon
Emerson
Funai
GE
Goldstar
If your VCR is this
...enter this code ...enter
brand...
01
O2
03
04, 05
06
03
07
this code
Philips 03, 10, 11
Quasar 03
RCA 08, 13, 20
Sanyc 14
Scot 15
Sharp 16
Sony 17, 18
Hitachi
JVC
Magnavox
Multitech
NEC
Panasonic
Philco
08
09
03, 10,11
06
12
03
03, 10
Sylvania
Symphonic
Teknika
Toshiba
Totevision
Zenith
03, 10, 11
06
04, '06
15
07
19
Release the POWER button.
Getting Started 37
To Next Page
Loading...
Need help?
General
