[:>Important: When you replace the batteries in your remote control, the remote
will return to its initial setting. The VCR layer will be set r,o control
Mitsubishi VCRs that have their remote switches set to "A"; the
AUX layer will be set to control Mitsubishi VCRs that have their
remote switches set to "B". Follow the steps above to re,_et your
remote control.
using your remote control to operate your VCR
After you have set up your remote control for your particular brand
of VCR, you can use the remote to operate your VCR.
O Set the TV/VCR/AUX switch on the remote control to "VCR"
or "AUX."
O Point the remote control at the VCR and press the desired
buttons.
If you are using a Mitsubishi VCR, you will be able to use all of the
buttons on the remote control to operate your VCR except for
MUTE, VOLUME and the PIP function buttons, which will always
operate the TV.
If you are using another brand of VCR, you can use tile POWER,
CHANNEL, REC, STOP, PAUSE, REW, PLAY and FF buttons to
operate your VCR.
using your remote control to operate your cable box
After you have set up your remote control for your particular brand
of cable box, you can use tlhe remote to operate your cable box.
Set the TV/VCR/AUX switch on the remote control to "VCR"
or "AUX."
Point the remote control at the cable box and press tlhe desired
buttons.
Only the POWER and CHANNEL buttons can be used when oper-
ating your cable box.
Getting Started 39
To Next Page
Loading...
Need help?
General
