Using the Super Quick View tuning (cont.)
[_ Important:
using the ENTER/CANCEL buttons to change the Super
Quick View memory
To enter a channel into the Super Quick View memory:
O Use the channel control (CHANNEL) to se]iect the channel you
want to add to the Super Quick View memory.
O While the channel number is still displayed on the screen, press
ENTER. Hold down the ENTER button until the letters "SQV"
appear on the screen.
Repeat steps O - _ until to add up to ten channels to the Super
Quick View memory.
0 Press the quick view (QV) button to cycle through the channels
you have memorized.
You can only memorize up to ten channels in the Super Quick "View
memory. If you try to memorize more than ten, the letters "SQV"
will flash, indicating that the memory is ful]. You must delete a
channel from memory before adding a new one.
[_ Important:
> Important:
[_ Important:
To remove a channel from the super quick view tuning:
O Use the channel control (CHANNEL) to select the channel you
want to remove from the Super Quick View memory.
O
While the channel number is still displayed on the screen, press
CANCEL. Hold down the CANCEL button uracil the letters
"SQV" disappear from under the channel number. The c]hannel
will be removed from the Super Quick View memory.
When there are channels programmed into the Super Quick View
(SQV) memory, the Quick View (QV) feature is not available.
You can display the present channel number by pressing the
DISPLAY button. This will allow you to add or remove a channel
from Super Quick View memory.
You cannot use the ENTER and CANCEL buttons to change the
SQV memory when you are watching an external source (such as
VCR.)
64 Chapter 3: Operating Your TV
To Next Page
Loading...
