63
DRIVE THE MOTOR
3
Make a start and stop with terminals (External operation)
7. Deceleration stop
Turn OFF the start switch (STF or STR). The
frequency value on the indication decreases
according to Pr. 8 Deceleration time and displays
" " (0.00Hz) when the motor is stopped.
[RUN] turns OFF.
REMARKS
Pr. 178 STF terminal function selection must be set to "60" (or Pr. 179 STR terminal function selection must be set to "61").
(all are initial values)
When Pr. 79 Operation mode selection is set to "3", multi-speed operation (Refer to page 64) is also valid.
Pressing to stop the motor and the display shows .
1. Turn the start switch (STF or STR) OFF.
2. The display can be reset by .
Operation Display
Forward
rotation
Reverse
rotation
OFF
Stop
To Next Page
Loading...
