74
Parameter list
3.6.2 Displaying the extended parameters
Operation Display
1.
Screen at powering ON
The monitor display appears.
2. Press to choose the PU operation mode.
PU indication is lit.
3. Press to choose the parameter setting
mode.
PRM indication is lit.
(The parameter number read previously
appears.)
4. Turn until " " (Pr. 160) appears.
5. Press to read the currently set value.
" " (initial value) appears.
6. Turn to change it to the set value " ".
7. Press to set.
Flicker...parameter setting complete!!
Turn to read another parameter.
Press to show the setting again.
Press twice to show the next parameter.
After parameter setting is completed, press once to show the fault history and press twice to return to
the monitor display. To change settings of other parameters, perform the operation in above steps 3 to 6.
REMARKS
If the setting has not been changed, the value does not flicker and the next parameter number appears.
Pr. 160 Description
9999
(initial value)
Only the simple mode parameters can be displayed.
0 Simple mode and extended mode parameters can be displayed.
To Next Page
Loading...
