Mitsubishi FREQROL FR-A024-0.1K - Page 18

2. NOMENCLATURE AND FUNCTIONS
Removing and Attaching the Acc08sory Cover
Insert the tip of a screw driver into the slot at the right side
of
the inverter and pull the handle of the screw driver up
around the slot to loosen cover.
Pull the cover toward you to T%moye.
To attach the accessory cover, insert the left edge of the
cover into the slot in the inverter and push the right side
of
the cover against the inverter.
Handling th. FFbARW03 Par#rwtr Copy Unk
The FR-ARWOS parameter copy unit can be connected to the inverter directly or with an op-
tional cable. Options, function settings, and operation status monitoring mn
be done, the same
as with the FR-PUO3. Note that the function assigned to the @ key on the FR-ARW03 dif-
fers from that on the FR-PUO3.
With the FR-ARW03
it is possible to read the inverter parameters set for individual applications
collectively and to copy them to other inverters.
Note: 1.
Do not copy the parameters between differing voltage classes or differing capacities.
If the parameters are copied between differing voltage classes or differing capacities,
the motor rotation may become unstable, unexpected alarms may occur, or the
inverter‘s performance may
be acheved. Contact Mitsubishi if the parameters are
copied by mistake.
2. If copying the parameters from old version to new version, the set value of Pr.31 and
Pr.81 changes. After parameter copy from old version to new version, manually set
“0” to Pr.31 and set ‘9999” to Pr.81 in new version.
Please see the following
serial number to distinguish new version. The serial number
is shown on the name plate. New version has the same or higher number.
FR-A024-0.1K lo 1.5K
-6-