Mitsubishi FREQROL FR-A024-0.1K User Manual

11. OPERATION
11.4 PU Operation Mode (Operation Using the Parameter Unit)
(1) Ordinary operation
By repeating items 2 and 3 below while the motor is running, it is possible to change the
motor speed.
Operation procedure (operation at 60th)
1 TumgONpnsr--
Tum
ON the power (POWER
~ ~ irdicabr lamp lit) ard press lhe
- , .. . [W OP] key. Make sure that the
W operat!m mode indicating
lenp is lit.
If indkating lamp is not lit,
chmQe the opemU0n mode to the
I /PUoperation # 1 PU operation mode by refemng to
I is directly set using the
Nob 1: The operaw frequency
numk keys Mer
preswng
Uw [PU OP]
key.
Direct setting is
not possible in the
monitor mode. To set
the operation frequency
dirdy while the
Inverter is in the
the procedure given on page 26. monkor mode, carrsl
the monitor mode by
pressing the [PU OP]
key
and set the new
2. Semg me opsrarion lreqoency
<Direct
operafwn~
. -. - - Set the operation
frequency
at 60HZ.
0 Direct setting (Note 1)
0 Step setting (Note 2)
(Note 3)
[.
Irl
,'
/ 3. wrisng IIW vabe of hequency
Press me [WRITE] key.
Be sure to press Re [WRITE] key after setting the
e is not stored to the memory if it is
4. Starling the mor
Press elther he [FWD] or [REV key.
The mtor starts runnmg The mode
automatically changes to the monbr mode
and lhe display unlt gives lhe w@Ut
frequency
5. Slopping !he motor
- - - Press the [STOP] key. me
mtor decelerates and stops.
-29-

Mitsubishi FREQROL FR-A024-0.1K Specifications

General

Brand	Mitsubishi
Model	FREQROL FR-A024-0.1K
Category	Inverter
Language	English