Features and controls
3-125
3
Programming HomeLink®
To program HomeLink® to operate a garage door, gate, or
entry door opener, home or office lighting, you need to be at
the same location as the device.
OTE
● Some garage door openers manufactured after 1996 have
“rolling code protection”. To program a garage door
opener equipped with “rolling code protection”; you will
need to access the garage door opener motor to press the
motor’s learn buttons. For convenience, use a ladder and
another person to assist you.
1. Unplug the device during the “cycling” process to prevent
possible damage to the garage door opener components.
2. Press and hold the 2 outer HomeLink® buttons (A) (to
clear the memory) until the indicator light (B) blinks
slowly (after 20 seconds). Release both buttons.
3. Position the end of the hand-held transmitter 1 to 3 inches
(25 to 75 mm) away from HomeLink® surface.
4. Using both hands, simultaneously press and hold both
HomeLink® button (C) you want to program and the
hand-held transmitter button (D). Do not release the but-
tons until step 5 has been completed.
5. Hold down both buttons until the indicator light on
HomeLink® flashes, changing from a “slow blink” to a
“rapidly flashing blink”. This could take up to 90 seconds.
When the indicator light flashes rapidly, both buttons may
be released. The rapidly flashing light indicates successful
programming. Press and hold Homelink® button and
observe the indicator light.
BK0121200US.book 125 ページ ２０１０年４月１４日 水曜日 午前１１時２４分
To Next Page
Loading...
