7-16
Vehicle care and maintenance
7
Checking battery electrolyte level
Use the following procedure to check the battery electrolyte
level.
1. Insert the tip of a screwdriver at the edge of the cap, pry
gently to remove the cap.
2. The inside of the battery is divided into several compart-
ments.
Check the electrolyte level (A) in each cell.
The electrolyte level must be within the range (B) shown
in the illustration.
If it is necessary to add fluid, add only distilled water. Do
not overfill above the top of the range because a spill dur-
ing driving could cause damage.
WARNING
!
● If the battery goes flat, be sure to check the battery
electrolyte level before connecting booster cables.
● After checking the battery electrolyte level, make
sure the caps are fitted securely.
● If any of the caps has a loose fit, replace the battery.
Cell
A
B = .31 in
(8 mm)
BK0121200US.book 16 ページ ２０１０年４月１４日 水曜日 午前１１時２４分
To Next Page
Loading...
Need help?
General
