6-20
For emergencies
6
OTE
● The wheel cover is made of plastic. Be careful when pry-
ing it off.
To install
Line up the air valve (A) with the valve opening (B) on the
wheel cover.
Then use your hand to strike around the outer edge of the
wheel cover to secure it in place.
OTE
● The full wheel cover is marked with a symbol (C) on the
reverse side that shows the air valve location.
Before installing the wheel cover to the wheel, make sure
that the opening with the symbol mark (C) is correctly
aligned with the air valve.
CAUTION
!
● Trying to remove the wheel cover with only your
bare hands can seriously injure your fingers.
BK0121200US.book 20 ページ ２０１０年４月１４日 水曜日 午前１１時２４分
To Next Page
Loading...
