UNDERBODY ANTICORROSION AGENT LOCATIONS
TSB Revision
CORROSION PROTECTION
4-7
UNDERBODY ANTICORROSION AGENT LOCATIONS
M4040009000024
In order to provide a greater corrosion resistance,
underbody corrosion prevention treatment should be
performed after undercoat application. After complet-
ing body repairs, restore this underbody corrosion
prevention treatment as indicated in the illustration if
necessary. Recommend wax:
• Tectyl 506T, 506 or S
• Waxoyl
NOTE: .
•
Take care not to permit the anticorrosion agent to
come in contact with body painting, brake parts,
exhaust pipes, bearing seals for rear axle and
rambler parts (such as tires and drive shaft
boots).
•
If anticorrosion agent gets onto the oxygen sen-
sor, it will cause a drop in the performance of the
sensor. Cover the oxygen sensor with a protec-
tive material when applying anti-corrosion agents
and undercoats.
AB202188
AB
:100 µ or more
To Next Page
Loading...
Need help?
General
