BODY REPAIR
BASE OF BODY REPAIR
9-26
3. Use the hammer and dolly to repair the dents and other
uneven surfaces of the panel.
(1) First repair the larger areas of damage so that they are as
close as possible to the original condition before the
damage occurred.
(2) Next repair the areas of moderate damage.
CAUTION
Care should be taken, as far as possible, not to permit the
panel plates to become elongated.
CAUTION
• Be careful not to file too much; this will reduce the
strength and rigidity of the panel.
• Do not use the file in one direction only; alternate use
in two directions diagonally opposite each other.
4. Next, file the area so that convex and concave parts are no
longer clearly visible, and at the same time remove small
projections.
5. After once again smoothing the clearly visible dents and
projections by using the hammer and dolly, follow step 4
above.
Alternately repeat hammering and filing until there are file
traces over the entire repair area.
6. Make a solder build-up at the repair.
7. Finally, finish up the solder build-up using a body file.
AB200101
(1)
(2)
(3)
AB200102
To Next Page
Loading...
