CORROSION PROTECTION
BASE OF BODY REPAIR
9-41
• After applying sealant to the door-stop, etc., clean away any
excess so as to be sure that there is no interference with
installed parts, etc.
UNDERCOATING
• Be sure to mask any parts installation holes, and
the area around the place where undercoating is
to be applied, before applying it.
• Be sure not to apply the undercoating to tires or
to the drive shaft and other drive components.
If the undercoating application inside the wheel
housing, on the under body, etc., is insufficient, it can
result in corrosion. Be sure, therefore, to apply a
good coating of undercoating to such parts after
repairs are completed.
AB200123
AB200124
: Undercoating application locations
AB
To Next Page
Loading...
Need help?
General
