BODY DIMENSIONS AND MEASUREMENT METHODS
BODY DIMENSIONS
2-2
BODY DIMENSIONS AND MEASUREMENT METHODS
M4020001000095
1. Type A (projected dimensions)
Indicates the dimension when a measurement location is
projected onto the plane.
The difference in height of the measurement points should
be taken into consideration when measuring.
2. Type B (actual-measurement dimensions)
Indicates the actual distance between the measurement
points.
Measure using a tracking gauge or a measuring tape, etc.
NOTE: .
•
Make the lengths of the tracking gauge probes the same
(A=A’).
•
Do not bend or twist the measuring tape.
3. Insert the tracking gauge probes securely into the measure-
ment holes.
4. When the standard dimensions in the illustration are
enclosed by oblong, this indicates that the symmetrical left
and right positions have the same dimensions.
5. When using a notch for dimension measurement, set the
measuring point at the center of the notch.
AB100778
PROJECTED DIMENSION
HEIGHT
PROBE
AB
AB100779
AB
ACTUALLY-MEASURED
DIMENSION
A
A'
AB100780AB100780
AB
CENTER OF HOLE
AB100781
AB
To Next Page
Loading...
