FRONT PILLAR
WELDED PANEL REPLACEMENT
3-16
7. Apply in advance body sealant in the areas shown in the
figure of the instructions when assembling the side outer
panel.
8. Assemble the side outer panel, then bolt and tape the hole
and flange with aluminum tape and fill the hole with foam
materials as shown in the figure of the instructions.
FOAM (Hole A): 3Mä ULTRAPRO Panel foam-Yellow
FOAM (Hole B): 3Mä Super panel filler
9. Wait 2 hours after filling the foam materials to remove the
bolt and aluminum tape, then melt the foam materials with a
soldering gun so a clip, etc. can thoroughly be inserted in
the hole filled with foam materials.
AB200475
AB
: BODY SEALANT
AB202041
AB
A
B
AB100787
To Next Page
Loading...
Need help?
General
