Mitsubishi OUTLANDER Service Manual

AK502868
1 mm
8.5 mm
3 mm
8.5 mm
1.75 mm
3 mm
AC
OIL PUMP CHAIN <4B11>
ENGINE OVERHAUL
11B-45
3. Squeeze liquid gasket of φ2.5 ± 0.5 mm in
thickness and apply it to the illustrated position of
the ladder frame.
Specified sealant:
ThreeBond 1217G or equivalent
AKB00722
AC
1
3
6
2
4
5
7
9
10
8
11
12
4. Tighten the ladder frame to the specified torque of
24
± 2 N⋅m in the order shown in the illustration.
>>B<< CRANKSHAFT SPROCKET
INSTALLATION
AK603521
AE
Crankshaft sprocket
Crankshaft
Engine
front
: Wipe clean with a rag.
: Wipe clean with a rag and degrease.
1. Wipe off the dirt on the crankshaft sprocket and
the crankshaft using a rag, and then remove the
grease from the portion shown in the illustration.
NOTE: Remove grease to prevent a drop in the
coefficient of friction of the pressing portion
caused by adhesion of oil.
2. Set the No. 1 piston at top dead centre on the
compression stroke.
3. Install the crankshaft sprocket to the crankshaft.
>>C<< OIL PUMP SPROCKET / OIL PUMP
CHAIN INSTALLATION
1. Set the No. 1 piston at top dead centre on the
compression stroke.
AK703732
AD
MB991346
Oil pump sprocket
2. Using the special tool Top cover wrench
(MB991346), install the oil pump sprocket to the
oil pump case.
3. Install the oil pump chain to the crankshaft
sprocket.
4. Install the oil pump chain to the oil pump sprocket.

Mitsubishi OUTLANDER Specifications

General

Brand	Mitsubishi
Model	OUTLANDER
Category	Automobile
Language	English