7B-6 Chapter 7 Part B Automatic transmission
6.1 Details of the steering column and shift lock cable ends
1 Steering wheel 5 Brake pedal
2 Shift lever
6 Column swifch i
3 Steering column
7 Lower column cover
4 Shift lock cable ends
~6.2 -Shift interlock cable end adjustment points
7.1 The kickdown band adjusting screw is located near
the shift control lever
the positions from “P” down to “L” and back. If it does not shift smoothly
adjust the shift interlock cable (see illustration).
Adjustment
Refer to illustration 6.2
2 To adjust the
interlockcable placetheshift lever in the”P”positron and
measure the clearance at point “A” and “B” at the steering column (see
illustration).
3 -Loosen the
interlock
cable end nuts and align the cable end to the
specifications listed in this Chapter.
4 Tighten
cable
nuts
and
check for proper shift lever movement as de-
scribed in step I.
7.5 The rear band adjusting screw is accessible after
removing the transmission oil pan
7 Bands -adjustment
Refer to illustrations 7. I, 7.5 2nd 7.9
Note: A/ways support the vehicle withjackstands.
Kickdown bands
Note: When the carburetor throttle is opened quickly (90% or more), the
kickdown valve opens app/y/ng fluid to the shift valves. The transmission _
then downshifts according to the veh/c/e speedand throttle pressure from
4to3,3to;!or2to f.-
1 Theadjustrng screwforthe krckdown band is located on the leftside off
the transmrssron (see Illustration).
To Next Page
Loading...
Need help?
General
