Mitsubishi PK12FK - Page 35

OC196A-35
TIMER OFF TIMER
CHECK SET TEMP.
DRY COOL
FAN
CLOCK AUTO AUTO
START STOP
MODE TIMER ON/OFF CLOCK/TIMER FAN SPEED AIR DISCHARGE FILTER
CHECK
TEST RUN
AIR SWEEP
SET TEMP. TIMER SET
F
FAN
SPEED
SWING
AUTO
RETURN
REMOTE CONTROLLER
2-2 DRY operation
<DRY operation time chart>
Minimum 3 minutes w1
ON
Thermostat
Indoor fan
Auto vane
Compressor
ON
DRY MODE
DRY MODE
ON
OFF
OFF
ON
OFF
OFF
Operation starts by
POWER button
ON.
Operation stops by
POWER button
OFF.
Room temperature
becomes equal to
set temperature.
Room temperature
rises above set
temperature.
w1 Even if the room temperature rises above the set temperature during this period, the compressor will not start until this
period has ended.
<How to operate>
1 Press POWER ON/OFF button.
2 Press the COOL / DRY button to set operation mode to “DRY”.
NOTE: “Cool” and “DRY” are alternately displayed each time COOL / DRY button
is pressed.
3 To set desired temperature, press WARMER or COOLER button.
NOTE: Set temperature changes by 2°F in the range 66~86°F, each time
WARMER or COOLER button is pressed.
<How to operate>
1 Press POWER ON/OFF button.
2 Press the MODE button to display “DRY”
3 Press the SET TEMP. button to set the desired temperature.
NOTE: The set temperature changes 2°F when the SET TEMP. button is pressed
one time.
Dry 65 to 87°F
CENTRALLY CONTROLLED
ON
ON/OFF
DRY
MODE SELECT COOL/DRY FAN
SET
TENPERATURE
WARMER
TIMER
FAN SPEED
LOW/HIGH
UP/DOWN
AIR
DISCHARGE
MODE
CHECK TEST RUN
HOURS
COOLER
FAN COOL
CHECK
SET TEMP
81
88
12
F
AUTO RETURN
HR
F
TIMER OFF
CHECK TEST RUN
AUTO STOP
AUTO START
LOW HIGH
POWER
SWING
STOP
(PK12/18/24/30/36FK)
PK12/18/24/30/36FK
1
PK18/24/30/36FK2
()
OC196A--2.qxp 1.12.19 10:40 AM Page 35