Mitsubishi PKFY-P63VKM-E.TH - Operation Procedure; Disassembly Procedure

PHOTOS & ILLUSTRATIONSOPERATION PROCEDURE
2727
DISASSEMBLY PROCEDURE
9
1. REMOVING THE PANEL
(1) Press and unlock the knobs on both sides of the front grille
and lift the front grille until it is level. Pull the hinges forward
to remove the front grille. (See Photo 1)
(2) Remove 3 screw caps of the panel. Remove 5 screws.
(See Photo 1)
(3) Unfix 3 hooks. (See Figure 1)
(4) Hold the lower part of both ends of the panel and pull it
slightly toward you, and then remove the panel by pushing
it upward.
(5) Remove the screw of the corner box. (See Photo 1)
Remove the corner box.
PKFY-P63VKM-E.TH PKFY-P100VKM-E.TH
PKFY-P63VKM-ER1.TH PKFY-P100VKM-ER1.TH
Be careful when removing heavy parts.
Figure 1
2. REMOVING THE ADDRESS BOARD, THE INDOOR
CONTROLLER BOARD, THE WIRELESS
CONTROLLER BOARD
(1) Remove the panel and the corner box. (Refer to
procedure 1)
(2) Remove the screw and hook of address board case. (See
Photo 2)
(3) Disconnect the connectors of address board.
(4) Remove the front and side electrical box covers (each 1
screw).
(5) Disconnect the connectors on the indoor controller board.
(See Photo 3)
(6) Remove the switch board holder and open the cover.
(7)
Pull out the indoor controller board toward you then
remove the indoor controller board and switch board. (See
Photo 3)
(8) Remove the holder of wireless remote controller board.
(9)
Disconnect the connector of wireless remote controller
board and remove the wireless remote controller board
from the holder.
Photo 2
Photo 1
Screws and screw caps
Screw of the
corner box
Front grille
Photo 3
Screw of address
board case
Water cut
Screw of
electrical box
cover (side)
Screw of electrical box cover
(Front)
Switch board
holder
Holder of wireless
remote controller board
Electrical box cover
(Front)
Indoor controller board
Terminal block (TB2)
Terminal block (TB5)
Terminal block (TB15)
Room temp. thermistor (TH21)
Hook
Screws
Hooks
OCH447B