Mitsubishi PUZ-A18NHA6 - Page 30

30
ON/OFF
TEMP
FAN
VANE
MODE
CHECK
LOUVER
TEST RUN
AUTO STOP
AUTO START
h
min
RESET
SET
CLOCK
TEST
RUN
COOL
7
5
6
2
3,4
Test run [for IR wireless remote controller]
Measureanimpedancebetweenthepowersupplyterminalblockon
theoutdoorunitandgroundwitha500VMeggerandcheckthatitis
equaltoorgreaterthan1.0M".
1Turnonthemainpowertotheunit.
2Pressthebuttontwicecontinuously.
 (Startthisoperationfromtheturnedoffstatusofremotecontroller
display.)
 andcurrentoperationmodearedisplayed.
3Pressthe()buttontoactivatemode,then
checkwhethercoolairblowsoutfromtheunit.
4Pressthe()buttontoactivatemode,then
checkwhetherwarmairblowsoutfromtheunit.
5Pressthebuttonandcheckwhetherstrongairblowsout
fromtheunit.
6Pressthebuttonandcheckwhethertheautovaneoperates
properly.
7PresstheON/OFFbuttontostopthetestrun.
Note:
• Point the remote controller towards the indoor unit receiver
while following steps 2 to 7.
• It is not possible to run in FAN, DRY or AUTO mode.
MODE
MODE
COOL
HEAT
TEST RUN
FAN
VANE
TEST RUN
OCH577A