Mitsubishi PUZ-A18NHA6 - FUNCTION SETTING; Unit Function Settings via Remote Controller; Functions by Unit Number (00)

95
12 FUNCTION SETTING
Function
Settings
Mode No.
Wired remote controller
(RF thermistor)
Setting No.
: Initial setting
(when sent from the factory)
Remarks
Power failure
automatic recovery
Indoor temperature
detecting
LOSSNAY
connectivity
Power supply
voltage
Frost prevention
temperature
Humidifier control
Change of
defrosting control
Not available
Available
Average data from each indoor unit
Data from the indoor unit with remote controllers
Data from main remote controller
Not supported
Supported (indoor unit dose not intake outdoor air through LOSSNAY)
Supported (indoor unit intakes outdoor air through LOSSNAY)
230V
208V
2: [36°F] (Normal)
3: [37°F]
When the compressor operates, the humidifier also operates.
When the fan operates, the humidifier also operates.
Standard
For high humidity
1
2
1
2
3
1
2
3
1
2
1
2
1
2
1
2
01
(101)
02
(—)
03
(103)
04
(104)
15
(115)
16
(116)
17
(117)
The setting is
applied to all
the units in the
same
refrigerant
system.
12-1. UNIT FUNCTION SETTING BY THE REMOTE CONTROLLER
Eachfunctioncanbesetaccordingtonecessityusingtheremotecontroller.Thesettingoffunctionforeachunitcanonlybe
donebytheremotecontroller.Selectfunctionavailablefromthetable1.
(1)Functionsavailablewhensettingtheunitnumberto00(Select00referringto4settingtheindoorunitnumber.)
<Table1>Functionselections
Meaning of "Function setting"
Mode02 : indoor temperature detecting
No. Indoor temperature(ta)=
No1. Average data of the
sensor on all the
indoor units
Initial
setting
ta=(A+B)/2 ta=(A+B)/2 ta=A ta=A
No2. Data of the sensor
on the indoor unit that
connected
with remote controller
ta=A ta=B ta=A ta=A
No3. Data of the sensor
on main remote
controller
ta=C ta=C ta=C ta=C
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
INDOOR
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
OUTDOOR
INDOOR
REMOTE
(MAIN)
OUTDOOR
INDOOR
REMOTE
(MAIN)
REMOTE
(SUB)
INDOOR
OCH577A