Mitsubishi QD75M1

5 - 73
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
Setting Value, setting range
Value set with peripheral device
Setting value buffer memory
address
Servo amplifier setting invalid ( : Invalid, : Valid)
MR-
H-BN
MR-
H-BN4
MR-
J2-B
MR-
J2S-B
MR-
J2-Jr
MR-
J2M-B
Value set with sequence program
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
Slight vibration
suppression
control setting
Electromagnetic brake interlock
output timing setting
0
Motor-less operation
selection
1: is used to set up the setting
value.
(Hexadecimal)
H
0000
H
30124 30224 30224 30424
Low pass filter selection
0
Adaptive vibration suppression
control selection
Adaptive vibration suppression
control sensitivity selection
1: is used to set up the setting
value.
(
Hexadecimal
)
H
0000
H
30125 30225 30325 30425
2: Set the parameter value and switch power off once (The parameter is transferred to servo amplifier from QD75), then switch it on
again to make that parameter setting valid.