Index - 4
Dwell time (Explanation of positioning terms)
..........................................................Appendix-76
Dwell time (JUMP destination positioning data
No.) (
Da.9
).................................................. 5-94
Dwell time during OPR retry (
Pr.57
)......... 5-56
Dynamic brake (Explanation of positioning terms)
..........................................................Appendix-76
[E]
Effective load torque (
Md.110
) .................. 5-136
Electrical specifications................................. 3-16
Electrical specifications sequence (
Pr.121
)
....................................................................... 5-68
Electromagnetic brake (Explanation of positioning
terms)................................................Appendix-76
Electronic gear (Explanation of positioning terms)
..........................................................Appendix-76
Electronic gear function............................... 12-13
Emergency stop ............................................ 6-70
Emergency stop (Explanation of positioning terms)
..........................................................Appendix-76
Encoder (Explanation of positioning terms)
..........................................................Appendix-76
Error and warning details.............................. 15-2
Error correction (Explanation of positioning terms)
..........................................................Appendix-77
Error detection signal .................................... 3-13
Error history................................................. 5-116
Error history pointer (
Md.13
) .................... 5-116
Error judgment (
Md.7
).............................. 5-114
Error reset (Explanation of positioning terms)
..........................................................Appendix-77
Error reset program....................................... 6-51
Execution data backup function.................... 13-5
Execution prohibition flag.............................. 3-12
External command ........................................ 3-19
External command function selection (
Pr.42
)
....................................................................... 5-42
External command function valid setting program
....................................................................... 6-36
External command valid (
Cd.8
)............... 5-142
External device connector............................... 4-3
External dimension drawing...........Appendix-111
External input/output signal (
Md.30
) ........5-124
External I/O signal logic switching function...13-7
External I/O signal monitor function ..............13-8
External regenerative brake resistor (Explanation
of positioning terms) .........................Appendix-77
[F]
F (Explanation of positioning terms)
...........................................................Appendix-77
Fast OPR .......................................................8-13
Fast OPR (Explanation of positioning terms)
...........................................................Appendix-77
Fatal stop........................................................6-70
Features of QD75 ............................................1-2
Feed pulse (Explanation of positioning terms)
...........................................................Appendix-77
Feed screw (Explanation of positioning terms)
...........................................................Appendix-77
Feedback pulse (Explanation of positioning terms)
...........................................................Appendix-77
Feed forward gain (
Pr.119
)..........................5-66
Feed back pulse (
Pr.106
) ............................5-60
Feedrate (
Md.22
) ......................................5-120
Fixed-feed (Explanation of positioning terms)
...........................................................Appendix-78
Flash memory (Explanation of positioning terms)
...........................................................Appendix-78
Flash ROM.......................................................7-2
Flash ROM write program .............................6-50
Flash ROM write request (
Cd.1
)..............5-138
Flat type motor (Pancake motor) (Explanation of
positioning terms)..............................Appendix-78
Flow of all processes .....................................1-22
Flow of system operation...............................1-22
FLS signal (Explanation of positioning terms)
...........................................................Appendix-78
Follow up function..........................................6-89
For creating program .......................................6-2
For installation..................................................4-7
For maintenance............................................4-15
For restarting..................................................6-69
For starting "fast OPR" ..................................6-60
For starting "machine OPR" ..........................6-59
For starting "major positioning control" .........6-60
For starting "position-speed switching control"
........................................................................6-61
To Next Page
Loading...
Need help?
General
