Mitsubishi QD75M1

Index - 13
Time chart for changing the speed using an
external command signal............................ 12-42
Time chart for changing the speed using the
override function.......................................... 12-45
Torque change function .............................. 12-51
Torque change program ............................... 6-45
Torque control (Explanation of positioning terms)
..........................................................Appendix-91
Torque limit function.................................... 12-25
Torque limit setting value (
Pr.17
) ............. 5-30
Torque limit stored value (
Md.35
)............ 5-128
Torque loop mode (Explanation of positioning
terms)................................................Appendix-91
Torque output setting value (
Cd.101
) ...... 5-160
Torque ripple (Explanation of positioning terms)
..........................................................Appendix-91
Tracking function (Explanation of positioning
terms)................................................Appendix-91
Turntable (Explanation of positioning terms)
..........................................................Appendix-92
Types and roles of control data .................... 5-18
Types and roles of monitor data................... 5-14
Types of data................................................... 5-2
Types of errors .............................................. 15-2
Types of stop processes............................... 6-71
Types of warnings......................................... 15-3
[U]
Unconditional JUMP.................................... 9-111
Unit magnification (
Pr.4
)........................... 5-22
Unit setting (
Pr.1
)...................................... 5-22
Unit setting (Explanation of positioning terms)
..........................................................Appendix-92
Upper limit...................................................... 3-18
[V]
Valid M code (
Md.25
)............................... 5-122
[W]
Wait start...................................................... 10-11
Warning (Explanation of positioning terms)
..........................................................Appendix-92
Warning history ........................................... 5-118
Warning history pointer (
Md.18
)............... 5-118
Window (Explanation of positioning terms)
..........................................................Appendix-92
Writing to the Flash ROM.............................. 13-6
WITH mode..................................................12-64
WITH mode (Explanation of positioning terms)
...........................................................Appendix-92
Work piece .................................................... A-14
[X]
X0 (QD75 READY) ........................................3-13
X1 (Synchronization flag) ..............................3-13
XY table (Explanation of positioning terms)
...........................................................Appendix-92
[Z]
Z phase (Explanation of positioning terms)
...........................................................Appendix-92
Zero signal (Explanation of positioning terms)
...........................................................Appendix-92
Zero speed (
Pr.130
).....................................5-74