Mitsubishi QJ71DN91 - Page 113

7 - 5 7 - 5
MELSEC-Q
7 PROGRAMMING WHEN EXECUTING THE MASTER FUNCTION
Command for setting the parameters
for the master function
Sets the node number of the
third slave node to 4 and
the message group to 3.
Sets the connection type of the
third slave node to polling.
Input byte module = 8,
output byte module = 8
Input word module = 0,
output word module = 0
Input double-word module = 0,
output double-word module = 0
Expected packet rate default
= 500 ms
Watchdog timeout action
default = Auto delete
Production inhibit time
default = 20 ms
Sets the node number of the
fourth slave node to 3 and
the message group to 3.
Sets the connection type of
the fourth slave node to bit strobe.
Input byte module = 4,
output byte module = 2
Input word module = 0,
output word module = 0
Input double-word module = 0,
output double-word module = 0
Expected packet rate
default = 500 ms
Watchdog timeout action
default = Timeout
Production inhibit time
default = 10 ms
Writes the parameter data into
the buffer memory.
I/O communication
start command
Command for setting
the parameters for
the master function
Command for setting the parameters for the master function