8 - 1 8 - 1
MELSEC-Q
8 PROGRAMMING WHEN EXECUTING THE SLAVE FUNCTION
8
8 PROGRAMMING WHEN EXECUTING THE SLAVE FUNCTION
This chapter explains programming when the slave function is executed.
8.1 System Configuration
The programs explained in this chapter are based on the following system
configuration:
1) The reception data is allocated from X200 to X27F, and the
transmission data is allocated from Y200 to Y27F.
2) If an error occurs, the error information is read to D500.
3) It is assumed that the QJ71DN91 (slave node) is mounted in slot 0 of
the basic base.
To Next Page
Loading...
