8 INSPECTION AND MAINTENANCE
Mitsubishi Diesel Engine S16R & S16R2 OPERATION & MAINTENANCE MANUAL
154
Pub. No. K29001-00320 Revision: 1
3 Check the high pressure fuel
injection pipe (3) for wear.
Fig. 8-46 High Pressure Fuel Injection Pipe - Check
• If wear is found, contact your SME
dealer
"CONTACT LIST" (→ Page 8).
4 Loosen clamp retaining bolt and
check wear of clip (4) and metal
contact between the pipe and the
clamp.
Fig. 8-47 Clip Attaching Direction
• Attach the clip to the clamp by facing
the position of the notch (5) of the
clip (4) toward the R side of the clamp
(1).
Fig. 8-48 Low Pressure Fuel Pipe - Check
• If wear or metal contact is found,
contact your SME dealer
"CONTACT
LIST" (→ Page 8).
Engine Oil System - Check
• When handling engine oil, refer to "5
ENGINE OIL" (→ Page 109).
• Devices and equipment outside the
scope of our supply are included in the
facility. For the details, refer to such a
document as the specification sheet
prepared by the generator supplier.
• For the devices and equipment outside
the scope of our supply, refer the
corresponding manual of the generator
and the supplier's operation manual.
• If automatic oil supply is provided, refer
to the corresponding manual of the
generator and the supplier's operation
manual.
(3)
R
R
R
(4)
(4)
(4)
(1)
(1)
(1)
(5)
(5)
(5)
Do not touch hot engine oil or parts.
* Otherwise, you could get burned.
Do not discard waste oil into
sewerage, river, lake or other similar
places.
* Be sure to discard waste oil in accordance with
the applicable laws and regulations.
(4)
To Next Page
Loading...
