Mitsubishi WS-55517 - Servicing the Lenticular Screen and Fresnel Lens; Removal of the Lenticular Screen and Fresnel Lens; PWB-SIGNAL-3 (VCJ; Vertical Deflection; Audio))

Page 9
MODELS: WS-55517 / WS-65517 / WS-73517
SERVICING THE LENTICULAR SCREEN AND FRESNEL LENS
WS-55517 / WS-65517 / WS-73517
CAUTION: Wear gloves when handling the Lenticular Screen and Fresnel Lens.
This prevents cuts and finger prints. Do not place Fresnel Lens in the sun.
This may cause fire and heat related injuries.
1b. Lenticular Screen and Fresnel Lens Removal
1. Remove the screen assembly as shown in the Cabinet Disassembly procedure.
2. Remove the Screen Frame top section by removing 4 screws (a).
3. Carefully grasp the Lenticular Screen and Fresnel Lens combination, and pull upward and out of the Screen
Frame Assembly.
Note: When separating the Lenticular Screen from the Fresnel Lens, use caution
while prying the Screen and Lens apart. Use a slot type screw driver, and
remove the pressure sensitive double sided tape.
(Rear View)