29
ENGLISH
Integration of the CD-ROM Into
Your Operating System
ATAPI CD-ROM
Windows 95
During the starting process, Windows 95 checks your computer hardware con-
figuration in order to identify new internal or peripheral devices. In some rare
cases, Windows 95 will not be able to clearly identify the installed hardware.
In such cases please check the hardware installation of the CD-ROM:
the connection to the IDE interface, if the IDE interface has been activated or
the interface cable correctly connected, and check for correct jumpering.
Windows NT
There are differences between installation under Windows NT 3.5x and
Windows NT 4.0.
In Windows NT 3.5x the required configuration utility „Win-NT-Setup“ is in
the ”Main” group. Start this utility and go to the Options menu item
„Add/Remove SCSI adapters“, select the driver „IDE CD-ROM (ATAPI)“,
confirm the selection, and reboot your computer.
The corresponding configuration utility is located in System Control under
Windows NT 4.0. Otherwise the driver installation is the same as under
Windows NT 3.5x.
Linux
Support of your CD-ROM drive is included in the operating system.
OS/2 Warp
OS/2 Warp automatically identifies your CD-ROM drive. For an installation
under OS/2 2.21, you require the drivers located on the disk in subdirectory
OS/2. Further information is contained in the ReadMe files on the diskette.
FX2400.2 20.10.2000 10:05 Uhr Seite 29
To Next Page
Loading...