Mitutoyo ABSOLUTE ID-F - Setting Parameters; Parameter Item Selection

37
No. 99MAH054A
5 Setting Parameters
(Short press) / (Long press)
5
Setting Parameters
5.1
Selecting Parameter Items
There are 10 types of parameter setting modes.
■List of parameters
Display Setting details Default setting
ModE Measurement mode selection Standard 1
unit Unit system selection in
dir. Counting direction selection Positive direction
rES. Resolution selection 0.0005 mm
0.00002 in
toL. Tolerance judgment result display
selection and allowed value setting
Display OFF
CALC. Calculation function selection and
calculationcoe󰀩cientsetting
Calculation OFF
A-bAr Analog bar display selection Display ON
S-SEL Switch function selection Default
F-Loc Function lock setting Lock OFF
othEr Change other functions -
CAL.ALt Calibration schedule warning
selection/setting
Warning OFF
outPut Digimatic output selection DIGIMATIC d2
rESEt All reset -