Mitutoyo ABSOLUTE ID-F - About This Document; How to Read This Document

vi
No. 99MAH054A
About This Document
This document is intended to provide an overview of the product, the functions
of each component, setup, usage and maintenance details.
■How to read this document
49
No. 99MAH054A
5 Setting Parameters
(Short press) / (Long press)
1 Press the [F2] key.
» Calculation function can be set.
2 Setting the execution/stop of the calculation function
1 Press the [F1] key or [F3] key.
» Each time the key is pressed, it will switch execution/stop.
2 Press the [F2] key.
When execution [on] is selected:
» The calculation function display (A) blinks and the previously set calculation
Tips
When stop [oFF] is selected:
»
(Go to "5.8 Selecting Analog Bar Display" on page 52.)
3
1 Press and hold the [F2] key.
» The sign will blink and can be changed.
» Continue to 3 if not changing the sign.
2 Press the [F1] key or [F3] key.
» Each time the key is pressed, it will switch the sign.
3 Press the [F2] key.
»
4 Press the [F1] key or [F3] key.
» Each time the key is pressed, the value will change by one.
5 Press the [F2] key.
»
» Each time the key is pressed, the blinking digit moves to the right.
Repeat steps 4 to 5
(e.g.: -6.4641).
»
6
»
(Go to "5.8 Selecting Analog Bar Display" on page 52.)
Indicates an operating
procedure to be performed or
its outline.
Indicates supplementary
information.
Indicates the reference
location.
Indicatesspecicwork
procedures.