Mitutoyo LGB - OUTPUT SIGNAL SPECIFICATIONS; All models other than 542-401

4 OUTPUT SIGNAL SPECIFICATIONS
4
OUTPUT SIGNAL
SPECIFICATIONS
4.1
All models other than 542-401
1
Output connector : RM12BPE-6PH (Manufacturer : Hirose)
2
Connector pin assignment
* Power supply to the Linear Gage(100mA)
The ripple of the power source should be less
than 200mV(p-p)
3
Output signal level : +5V (4.8V to 5.3V, 80mA) :
φA, φA, φB, φB, TTL output (equivalent to line driver SN75158)
4
Timing chart
(for LGB-0105L: 0,1µm)
5
Receiving connector and receiver Connector (RM12BRD-6S, Hirose) Receiver
(Equivalent to differential input line receiver SN75182)
6
Maximum cable length 20m
(using an optional extension cable)
7
Basic circuitry for processing received signals The following diagrams show the basic circuitry for processing
the signals from the Linear Gage, and the waveforms of the output signals.
5
No.: 4685
⑦