Users are in full charge of properly operating this aircraft. Manufacturers and dealers disclaim any responsibility for damages caused by misuse.
Keep the small accessories away from kids to avoid an accident.
Flight safety guidelines
Hobby-grade radio control aircraft is somewhat considered to be the highest danger potential article Users should firmly uphold the principle of “safety comes first” Never fly the
aircraft near airports, above crowds or in zones storing dangerous goods and understand the responsibility of the accident may cause by improper operations
Stay away from obstacles, crowds, power lines, trees or waters
Always choose a wide-open area for every flight, well away from people and property. Never fly directly over people or animals Please don’t fly in such bad weather conditions
as high temperature, snow, strong wind(level 5), rain or fog. Maintain a 7ft (2m) distance from the aircraft when taking off and landing.
Keep the aircraft in a dry environment
The aircraft is composed of sophisticated electronic components and mechanical parts To avoid damages on the mechanical and electronic components, please keep the
aircraft in dry environment and use a clean cloth to wipe the surface and keep it clean.
Practice flying together with skillful pilot
Beginners are suggested to practice flying together with skillful pilot guidance. Do not fly alone.
Bear proper operation and safe flight guidelines in mind
Please take a careful look at the manuals before flights for important information of product functions
and operation tips, and learn how to use the accessory, safe flight always comes first. Stay informed of and abide strictly by relevant local laws and regulations. Keep away from
any non-flight zones and respect other people’s privacy.
Safe flying
Please make sure you are in good shape mentally before every flight. Fly the aircraft as per your flying
experience. Never fly under influence of alcohol or drugs. Keep the remote controller at least 20 cm away
from your body when flying the aircraft.
Keep distance from a flying aircraft
Never use your hands to touch a flying aircraft under any circumstance. Don’t approach and touch a landed aircraft before its propellers are completely locked.
Keep away from heat source
The aircraft is made of metal, fiber, plastic, electronic component,s, and other materials Please keep it away from the heat source to avoid deformation or even damage caused
by sun exposure and high temperature.
Environmental protection requirements
To protect our blue planet, so please recycle the aircraft as per local laws and regulations.
Product profile
Product configuration
Product/spare parts included in the box
B3 fuselage(camera not included) X1
Extra Propellers AB X2
High landing gear x4
Remote controller xT
Battery xT
Charger x1
Screwdriver x
Protecting guard x4
Propeller changing tool xT
Camera holder X1
Technical parameter of the aircraft
Diagonal: 310mm
Overall height: 140mm
Brushless motor: 1806
Gross Weight: about 485g (with high landing gear, protecting guard, battery)
Battery: 7.4/1800 mAh
Charging Time: about 5 hours
Maximum flying time: about 18 minutes (without mounting the high landing gear and protecting guard)
Product assemble
Propellers installation/removal
Installation
Install propeller A and propeller B on the corresponding motor shaft and fix the rotor propellers tightly by
rotating them as per the “lock” direction shown on the propellers
Removal
Fix the brushless motor by rotor blade changing tool and then rotate and remove the propellers as per
the “unlock” direction showed on the propellers
Please make sure that the clockwise and the counter-clockwise propellers are installed on the correct motors because the aircraft will not fly normally for wrong propellers
installation.
Be careful when installing the propellers, as they are a little sharp.
Please use MJX propellers for this aircraft.
Extra propellers can be ordered additionally.
Protecting guard installation
First, release the two screws from the bottom of the motors Then, install the protection guard on the corresponding position, and fix the screws in a clockwise rotation.
To Next Page
Loading...
