How to charge the battery with charging device B:
1. Connect the balance charger to any USB interface (5V adapter or any device with USB interface) by
the USB cable. At this moment, the red light is solid on and the green light is off
2. Insert the triplex-wire plug of the battery into the triplex-wire socket of the balance charging controller
and charging is proceeding,
3. The green light keeps flashing slowly and the red light keeps solid on when the battery is being charged,
when charging is finished, both of the green light and red light keep solid on. Once there is any
malfunction, the red light will be solid on and the green light will keep flashing rapidly. Full Charging takes about 5 hours.
How to charge the battery with charging device C:
1. Connect the charger plug with the power outlet, plug the charger wire into the socket located at the night
side of the balance charging controller. At this moment, red light and green light are both solid on,
2. Insert the triplex-wire plug of the battery into the triplex-wire socket of the balance charging controller
and charging is proceeding,
3. The green light is off and the red light is on when the battery is being charged. Greenlight and the red light will be both on once the battery is full charged. Full Charging takes
about 5 hours
Attention It Is recommended to use the 5V 1-2A adapter for charging If charging by
device B.
Need adult supervision when this model is being played by children.
Only batteries of the same or equivalent type as recommended are to be used.
insert batteries with the correct polarity.
Non-rechargeable batteries are not to be charged; the transmitter need 4 X AA batteries for Work ·Do
not mix old and new batteries.
Do not mix alkaline, standard(carbon-zinc), or rechargeable(nickel-cadmium) batteries.
Rechargeable batteries are to be removed from the toy before being charged.
Rechargeable batteries are only to be charged under adult supervision.
Exhausted batteries are to be removed from the toy.
The supply terminals are not to be short-circuited.
The charing line to be used with the product should be regularly examined for potential hazards, such as damage to the cable or cord, plug, enclosure of other parts, and that in
the event of such damage,the product must not be used until that damage had been properly removed.
Major parts of the model
Major parts of the remote controller
To Next Page
Loading...
