Remote controller
How to connect the signal of the aircraft with the remote controller
Press the red button on top of the remote controller and turn on the power of the remote controller.The remote controller will send out 2 beep sounds, and the indicator lights
keep flashing, the remote controller is under signal connection status.
Turn on the aircraft. Once the signal connection is done The remote controller will send out a long beep
sound and the indicator light keeps solid green.
How to lock and unlock the aircraft
Unlock the aircraft
Once the gyro detection of the aircraft is finished, the front lights of the aircraft keep solid. Short-press the red button(indicated as below photo) After a long beep sound from the
remote controller, the rear lights of the aircraft keep solid, as well. And the motors rotate slowly, the aircraft is unlocked.
Lock the aircraft
Pull down the throttle stick to the bottom position, long-press the red button (indicated as below photo)
The remote controller sends out an interrupted beep sound Then, the motors stop rotating, and the rear
indicator light is off, which means that the aircraft is locked,
Warnings: The throttle control stick should be pushed to the bottom position when long-press the red button to lock the aircraft. Otherwise, the
aircraft could not be locked.
Remote controller calibration
Keep pressing the red button on top of the controller and slide the power switch to the ON position Push down the calibration button and hold on for 3 seconds. The remote controller
will send out 3 beep sounds; the indicator light of the aircraft turns from flashing quickly to slowly. Maximum rotate both of the left and night control stick to any direction for 2 circles.
Then, again, push down the calibration button and hold on for 3 seconds. The remote controller will send out 3 beep sounds; the indicator light of the model turns from flashing slowly
to quickly, which means that remote controller calibration is completed Warm tip:
All remote controllers have been calibrated when manufacturing
Remote controller calibration is requested only if pilots find that the remote controller control sticks are not working normally.
Signal connection is done once for all if it is not connected with other aircraft.
Set the connection one by one to avoid signal connection error.
To Next Page
Loading...
