USER MANUAL | T10 & NC8/NS8
Check the Power Supply
1. Be sure the wall outlet that the power supply is plugged into is working
(plug another device into it and see that it works properly).
2. Be sure the wire that plugs into the side of the transmitter is plugged in
securely.
If the transmitter powers up from a known good power supply, but
not from the charger power supply, you probably have a bad charger
power supply. Call MMCall for a replacement or repair.
Charging Check
Please take note of the following charging requirements and functions.
1. Watches should be placed on charging squares with pins facing into metal
connectors on back of watch.
2. Micro USB should be plugged in with USB plugged in to power supply.
3. Watches charge best with longer strap on table beneath charging square,
with watch face facing up.
Service Questions and Answers
What to do if the system malfunctions?
Should your paging system ever fail to function properly, refer to the
previous troubleshooting section. If you’ve followed all the steps and
requirements and your system is still inoperable, you may call MMCall at
(855) 638-2034 Monday through Friday 9:00 am to 5:00 pm Eastern Time.
To Next Page
Loading...